Schematic Circuit Diagrams for the Novaturn

Steve · Mon 22 Feb , 2010 15:10 pm

smartstep.zip: (235.13 KiB) Downloaded 688 times

Turn.zip: (617.18 KiB) Downloaded 1915 times

MadeForThat · Fri 13 Sep , 2019 18:20 pm

I only see half of the denstep card and half of the nextstep terminal blocks, does anyone have the upper side of the denstep and the lowerside of the nextstep? I am looking for specifically how the speed/feed pots are set up

Martin · Mon 16 Sep , 2019 10:03 am

Both bottom cards are the same so use the same connections.

MadeForThat · Mon 16 Sep , 2019 18:34 pm

thanks martin,
Perhaps this is a stupid question, but the "control voltage" on the machine tags just refers to the component voltage outputs, not the operating voltage of the the control card itself, correct?

Martin · Tue 17 Sep , 2019 7:58 am

viewtopic.php?f=54&t=2126

LucDav · Sun 10 May , 2020 15:38 pm

Thanks for the schematics, i am currently trying to build a new set of electronics for my novaturn as none came with it. I am looking at the spindle drive and the encoder feedback does anyone have any ideas about the missing page 4? Is the encoder feedback converted into a tacho signal?

TDIPower · Mon 11 May , 2020 12:22 pm

Have a look at the info for the Starturn 5 I think its the same 'british encoder' I looked into it a while ago as i am converting my ST5 to Novaturn control

https://www.denfordata.com/bb/viewtopic.php?f=46&t=585

https://www.denfordata.com/bb/viewtopic. ... sh+encoder

https://www.denfordata.com/bb/viewtopic. ... der#p10871

Information