All info relating to the Denford NovaTurn CNC lathes
Moderators: Martin, Steve, Mr Magoo
-
Steve
- CNC Guru

- Posts: 1451
- Joined: Tue 21 Feb , 2006 16:15 pm
- Location: Denford UK
Post
by Steve » Mon 22 Feb , 2010 15:10 pm
- Turn.zip
- (617.18 KiB) Downloaded 1678 times
-
MadeForThat
- CNC Apprentice

- Posts: 91
- Joined: Mon 20 May , 2019 15:15 pm
- Hardware/Software: Micromill 2000:
Nextstep-4 axis
Novaturn ns:
denstep card (from swap)-atc
Post
by MadeForThat » Fri 13 Sep , 2019 18:20 pm
I only see half of the denstep card and half of the nextstep terminal blocks, does anyone have the upper side of the denstep and the lowerside of the nextstep? I am looking for specifically how the speed/feed pots are set up
-
Martin
- CNC Guru

- Posts: 1916
- Joined: Fri 24 Feb , 2006 17:09 pm
- Location: Brighouse
Post
by Martin » Mon 16 Sep , 2019 10:03 am
Both bottom cards are the same so use the same connections.
-
MadeForThat
- CNC Apprentice

- Posts: 91
- Joined: Mon 20 May , 2019 15:15 pm
- Hardware/Software: Micromill 2000:
Nextstep-4 axis
Novaturn ns:
denstep card (from swap)-atc
Post
by MadeForThat » Mon 16 Sep , 2019 18:34 pm
thanks martin,
Perhaps this is a stupid question, but the "control voltage" on the machine tags just refers to the component voltage outputs, not the operating voltage of the the control card itself, correct?
-
Martin
- CNC Guru

- Posts: 1916
- Joined: Fri 24 Feb , 2006 17:09 pm
- Location: Brighouse
Post
by Martin » Tue 17 Sep , 2019 7:58 am
-
LucDav
- Posts: 25
- Joined: Wed 27 Sep , 2017 20:46 pm
Post
by LucDav » Sun 10 May , 2020 15:38 pm
Thanks for the schematics, i am currently trying to build a new set of electronics for my novaturn as none came with it. I am looking at the spindle drive and the encoder feedback does anyone have any ideas about the missing page 4? Is the encoder feedback converted into a tacho signal?
-
TDIPower
- CNC Guru

- Posts: 613
- Joined: Tue 29 Apr , 2014 18:38 pm
- Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto
Post
by TDIPower » Mon 11 May , 2020 12:22 pm