Compact 1000 not connecting

boots · Post by **boots** » Tue 21 Apr , 2009 21:40 pm

Compact 1000
VR Milling v5.26

The machine has been working fine until today.
Tried to connect to the machine and the error message "Must Use A Set xxxlink Function" pops up.
There is a "-" in the orange LED Status Display.

Any ideas on what to try?

Thanks

Martin · Post by **Martin** » Tue 21 Apr , 2009 22:27 pm

viewtopic.php?t=9

boots · Post by **boots** » Wed 22 Apr , 2009 19:26 pm

This unfortunately did not help. We are still getting the same error and we tried re-installing the drivers, restarted and checked the cables etc. We are also getting the error E06D7363 after we start VR Milling and try to connect to machine.

bradders · Post by **bradders** » Thu 23 Apr , 2009 9:17 am

Boots,

If it is a USB connection try a cable directly from the PC to the Baldor control board. It could be that the USB bulkhead fitting is faulty. Just to be 100% sure you could try a different USB cable as well

Post by **Denford Admin** » Thu 23 Apr , 2009 9:24 am

It'll be worth installing Mint Workbench off the VRMilling CD - See if that can find the machine.

Another thing to try is this:
viewtopic.php?t=2061

boots · Post by **boots** » Fri 24 Apr , 2009 17:13 pm

Thanks. It took several driver re-installs but we got it working

Information