Triac RS232 lead - Pin layout?

Grant_robochallenge · Post by **Grant_robochallenge** » Mon 08 Dec , 2008 12:38 pm

Hi, I am trying to run my 1984-5 Triac via BobCad/Cam on my PC but I do not have the required RS232 cable.
I have bought the connectors to make up a lead, and I am unsure of the pin layout.
Any one have any idea?
Thankyou

Andycnc · Post by **Andycnc** » Mon 08 Dec , 2008 12:54 pm

from the orac manual (should be the same as triac)

Andycnc · Post by **Andycnc** » Mon 08 Dec , 2008 12:58 pm

try also
https://www.denfordata.com/downloads/dos/triac.zip

this may help testing your 232 connection.

You may also find the manuals for the triac here, though I've not checked.

Grant_robochallenge · Post by **Grant_robochallenge** » Mon 08 Dec , 2008 16:01 pm

Hi Andy, thankyou for that info - but on the Triac it is a 7 pin DIN connector, and not the same as the Orac sadly.
Although I could have done with that info you gave me for a freinds Orac

Andycnc · Post by **Andycnc** » Mon 08 Dec , 2008 17:09 pm

sorry for the missleading info!
In the manuals dowload section is the scanned manual for the triac- there are connection details there

https://www.denfordata.com/downloads/dos/manuals.zip

Grant_robochallenge · Post by **Grant_robochallenge** » Tue 09 Dec , 2008 17:05 pm

Thank you very much Andy - I think I've found what im looking for from your link.

Regards

Denford Software & Machines

Denford Software & Machines

Triac RS232 lead - Pin layout?

Triac RS232 lead - Pin layout?

rs232 pinout

data

triac 232