Anyone fancy a cheap viceroy ?,
This one is going for £2400 if you fancy a bargain.
( Yes I know its a buy it now price !)
https://www.ebay.co.uk/itm/Viceroy-TDS-3 ... 2ec06d9f19
CNC Expert
Posts: 119
Joined: Wed 11 Aug , 2010 14:17 pm
Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
Location: Scotland !
CNC Expert
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Site Admin
Looks in good condition!
I've no idea what these are worth...is it a good price ??
I've no idea what these are worth...is it a good price ??
CNC Guru
Posts: 396
Joined: Mon 20 Nov , 2006 18:19 pm
Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
Location: East Midlands, UK
CNC Guru
No!Denford Admin wrote:Looks in good condition!
I've no idea what these are worth...is it a good price ??
Complete cloud cuckoo land, as far as I'm concerned!
There was a 280VS on last week - went for £840 IIRC.
Andy
CNC Apprentice
CNC Apprentice
A dealer has one in uk for £450 + vatAndy B wrote:No!Denford Admin wrote:Looks in good condition!
I've no idea what these are worth...is it a good price ??
Complete cloud cuckoo land, as far as I'm concerned!
There was a 280VS on last week - went for £840 IIRC.
Andy