Anyone fancy a cheap viceroy ?,
This one is going for £2400 if you fancy a bargain.
( Yes I know its a buy it now price !)
https://www.ebay.co.uk/itm/Viceroy-TDS-3 ... 2ec06d9f19
Viceroy for sale on Ebay
Moderators: Martin, Steve, Mr Magoo
-
LesT
- CNC Expert
- Posts: 119
- Joined: Wed 11 Aug , 2010 14:17 pm
- Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc. - Location: Scotland !
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Viceroy for sale on Ebay
Looks in good condition!
I've no idea what these are worth...is it a good price ??
I've no idea what these are worth...is it a good price ??
-
Andy B
- CNC Guru
- Posts: 396
- Joined: Mon 20 Nov , 2006 18:19 pm
- Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
- Location: East Midlands, UK
Re: Viceroy for sale on Ebay
No!Denford Admin wrote:Looks in good condition!
I've no idea what these are worth...is it a good price ??
Complete cloud cuckoo land, as far as I'm concerned!
There was a 280VS on last week - went for £840 IIRC.
Andy
-
graham4877
- CNC Apprentice
- Posts: 47
- Joined: Mon 10 Nov , 2008 10:30 am
- Location: newcastle uk
Re: Viceroy for sale on Ebay
A dealer has one in uk for £450 + vatAndy B wrote:No!Denford Admin wrote:Looks in good condition!
I've no idea what these are worth...is it a good price ??
Complete cloud cuckoo land, as far as I'm concerned!
There was a 280VS on last week - went for £840 IIRC.
Andy