Starturn pc software and purchase
Moderators: Martin, Steve, Mr Magoo
Starturn pc software and purchase
Hi, I have been offered a Starturn PC, without any software, What software is available and at what cost, I have used starmill pc and have it operating. Is the vr milling similar to the VRturning ?
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Starturn pc software and purchase
Yes they are similar although VR turning is a bit older now than VRMilling v5
What software runs the machine depends on whether it has had a DOS upgrade chip fitted, or USB upgrade.
If not then you'd have to find the DOS software to control it with, preferably, an old PC
DOS Software and Control Boards:
viewtopic.php?t=738
What software runs the machine depends on whether it has had a DOS upgrade chip fitted, or USB upgrade.
If not then you'd have to find the DOS software to control it with, preferably, an old PC
DOS Software and Control Boards:
viewtopic.php?t=738