DOS software and control boards
Directory Name, Machines supported, Control Manufacture, Control Type
Drivers2 All N/A All
Fanucmd.tri Triac, Novamill Optimised Eurocard
Fanucms Triac Servo Optimised STE Bus
Fanucsld Starturn 5 GSM LCB3
Fanucsmd Starmill Optimised Eurocard
Flstep Novaturn Optimised Smartstep, Eurocard
Flstep Mirac Optimised Smartstep, Eurocard
Flstep Cyclone Optimised Smartstep, Eurocard
Flstep TU150 E Optimised Smartstep, Eurocard
Flstep Microturn Optimised Smartstep, Eurocard
Heiden.sm Starmill Optimised Smartstep, Eurocard Heiden.tri Triac Optimised Eurocard
Mirac Mirac GSM LCB3
TU150 TU150 Servo Optimised STE Bus
TU150E TU150E Optimised Eurocard
CNC Guru
CNC Guru
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
I believe this table shows which DOS software to use for which machine 
EDIT - Table tags not working too well so look at the attached .pdf instead
EDIT - Table tags not working too well so look at the attached .pdf instead
| Directory Name | Machines supported | Control Manufacture | Control Type |
| Drivers2 | All | N/A | All |
| Fanucmd.tri | Triac Novamill | Optimised | Eurocard (3U) |
| Fanucms | Triac Servo | Optimised | STE Bus |
| Fanucsld | Starturn 5 | GSM | LCB3 |
| Fanucsmd | Starmill | Optimised | Eurocard |
| Flstep | Novaturn, Mirac, Cyclone, TU150 E, Microturn | Optimised Smartstep | Eurocard ? |
| Heiden.sm | Starmill | Optimised Smartstep | Eurocard ? |
| Heiden.tri | Triac | Optimised Smartstep | Eurocard ? |
| Mirac | Mirac | GSM | LCB3 |
| TU150 | TU150 Servo | Optimised | STE Bus |
| TU150E | TU150E | Optimised | Eurocard ? |