Starturn Conversion in Ashton U Lyne

Len-tikular · Post by **Len-tikular** » Thu 26 Mar , 2009 21:42 pm

Does anyone know who is offering the conversion service for Starturn5 in Ashton-U-Lyne?

Post by **Denford Admin** » Fri 27 Mar , 2009 11:00 am

Do you mean a Mach 3 conversion ?

Len-tikular · Post by **Len-tikular** » Fri 27 Mar , 2009 20:03 pm

Yes! I'd like to use Mach3 with my Starturn5. I had seen on your board ( I could be mistaken) a message from someone in Ashtun U Lyne who was offering to convert these machines.

I'd be grateful if anyone offering this service would get in touch.

Many thanks.

Meanwhile I'd like to get it running with the present controller but I'm finding the software a bit of a jungle.

What software?
What platform?
How to unstall?

If anyone has put together a simple install routing to get the Starturn5 running I'd like very much to hear from them.

Post by **Denford Admin** » Mon 30 Mar , 2009 9:23 am

viewtopic.php?t=1096

davidimurray has done a couple of starturns converted mach, I believe
If you can find him in the membelist, there will be a list of his posts.

Denford Software & Machines

Denford Software & Machines

Starturn Conversion in Ashton U Lyne

Starturn Conversion in Ashton U Lyne

Mach3 conversion