Posts: 20
Joined: Mon 23 Mar , 2009 10:00 am
Does anyone know who is offering the conversion service for Starturn5 in Ashton-U-Lyne?
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Posts: 20
Joined: Mon 23 Mar , 2009 10:00 am
Yes! I'd like to use Mach3 with my Starturn5. I had seen on your board ( I could be mistaken) a message from someone in Ashtun U Lyne who was offering to convert these machines.
I'd be grateful if anyone offering this service would get in touch.
Many thanks.
Meanwhile I'd like to get it running with the present controller but I'm finding the software a bit of a jungle.
What software?
What platform?
How to unstall?
If anyone has put together a simple install routing to get the Starturn5 running I'd like very much to hear from them.
I'd be grateful if anyone offering this service would get in touch.
Many thanks.
Meanwhile I'd like to get it running with the present controller but I'm finding the software a bit of a jungle.
What software?
What platform?
How to unstall?
If anyone has put together a simple install routing to get the Starturn5 running I'd like very much to hear from them.
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
viewtopic.php?t=1096
davidimurray has done a couple of starturns converted mach, I believe
If you can find him in the membelist, there will be a list of his posts.
davidimurray has done a couple of starturns converted mach, I believe
If you can find him in the membelist, there will be a list of his posts.