Hi
I have been advised by a Denford rep that I can remove all filters and run a tube from the bottom extraction port through the wall to extract to the outside and the machine will work well and will never need a filter again. Given the rising costs of filters and the falling funding of my dept this appears to be a good option.
Any advise / comments?
CNC Apprentice
Posts: 35
Joined: Fri 01 Dec , 2006 16:35 pm
CNC Apprentice
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Site Admin
See this post I've just done on extraction:
viewtopic.php?f=5&t=2612
viewtopic.php?f=5&t=2612