I am converting a Triac for mac3 operation.
I am keeping the power supply and stepper motors
What is the most suitable size of driver and break-out board?
Thanks
Dave Mann
P.S any information on the conversion would be great
Triac Drivers
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Triac Drivers
These other posts / users should be able to help:
viewtopic.php?f=4&t=1108&hilit=triac+upgrade
viewtopic.php?f=4&t=1763&hilit=triac+mach
viewtopic.php?f=4&t=1108&hilit=triac+upgrade
viewtopic.php?f=4&t=1763&hilit=triac+mach
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Triac Drivers
Just in case you hadn't realised, those posts cover more than one page...there are page numbers listed on the right at the top and bottom of each page...it's not the most obvious thing.-
davemusicmann
- Posts: 12
- Joined: Thu 14 Jan , 2010 14:35 pm
Re: Triac Drivers
I have some details on the motors used on this machine:-MHY200 3424 310 A8 and HY.200-3450-350-A8davemusicmann wrote:I am converting a Triac for mac3 operation.
I am keeping the power supply and stepper motors
What is the most suitable size of driver and break-out board?
Thanks
Dave Mann
P.S any information on the conversion would be great
I would like imformation on suitable drivers
Thanks
Dave Mann
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Triac Drivers
Hopefully someone can help with the motor info.
Most people seem to retrofit Gecko or Astrosyn drives - I would guess that you'd need 2 Amp for XY and 5 for the Z ? Any details you can find on the current drives would help ... are they Parker SD ? files/sd2_179.pdf
Most people seem to retrofit Gecko or Astrosyn drives - I would guess that you'd need 2 Amp for XY and 5 for the Z ? Any details you can find on the current drives would help ... are they Parker SD ? files/sd2_179.pdf