Micromill electrical diagrams ?
Moderators: Martin, Steve, Mr Magoo
Micromill electrical diagrams ?
Has anyone out there got a wiring diagram for the micromill please?
Re: Micromill
What is the age of the machine?
Where are you located?
Do you have a problem with it?
Where are you located?
Do you have a problem with it?
Re: Micromill
Unshure of its age but the main circit board was produced by:
OPTIMISED CONTROL LIMITED
BRISTOL
D771 ISSUE 2
4202
The previouse owner decided to take all the wires out to convert it to mac i have identified the stepper motors but i want to get the speed controll working i am in county Cleveland
OPTIMISED CONTROL LIMITED
BRISTOL
D771 ISSUE 2
4202
The previouse owner decided to take all the wires out to convert it to mac i have identified the stepper motors but i want to get the speed controll working i am in county Cleveland
Re: Micromill
Could you take a photo of the electrical panel?
Re: Micromill
- DSCF0650.JPG (76.56 KiB) Viewed 20815 times
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Micromill
Hopefully these drawings will give you enough info...
viewtopic.php?f=15&t=2495
viewtopic.php?f=15&t=2495
Re: Micromill
Hi,
The board you have is earlier than anything I have drawings for.
I suspect it would be a very basic circuit.
I attach a diagram for a smart step which was the following generation machine.
The board you have is earlier than anything I have drawings for.
I suspect it would be a very basic circuit.
I attach a diagram for a smart step which was the following generation machine.
- Attachments
-
- SMARTSTEP SCHEMATIC.pdf
- (112.34 KiB) Downloaded 1356 times