Cyclone Air Chuck

jaycnc · Post by **jaycnc** » Tue 03 Nov , 2009 0:02 am

I have an original Cylone Air chuck made by Leader with about 70 collets with a mix of both round and hex type.
Some of the collets are the same size but their is atleast one full set of round and nearly a full set of hex and most are all ok with the odd one needing new plastic spacers.
Im thinking of putting this up for sale but iv no idea what to ask for it so any suggestions please????
It has got the foot pedal as well.

thanks
jay

jaycnc · Post by **jaycnc** » Tue 03 Nov , 2009 21:53 pm

Anyone with any idea at all of what its worth please?

Triac whizz · Post by **Triac whizz** » Mon 09 Nov , 2009 12:49 pm

Perhaps if we saw a picture of it....

Post by **Denford Admin** » Mon 09 Nov , 2009 12:54 pm

We asked the Pratt Burnerd rep. on Friday but he had no idea- sorry!

jaycnc · Post by **jaycnc** » Mon 09 Nov , 2009 22:34 pm

Triac whizz wrote:Perhaps if we saw a picture of it....

Will take some pics tomorrow and post them

Triac whizz · Post by **Triac whizz** » Wed 18 Nov , 2009 13:28 pm

with eager anticipation, we wait...

sounds like yoda talk

Information