Hi again,
Yesterday when I went to click on the VR milling icon it asked me to register it, I had with the floppy in the past. I went through the upgrade reg. process and put in the floppy. It found the sec. file but then kept saying not registered and terminating. Im using V5. Can you help.
Thanks
problems with registration disc
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: problems with registration disc
Try using regrights - see the last post in this thread:
viewtopic.php?f=8&t=2321
viewtopic.php?f=8&t=2321
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Re: problems with registration disc
Because, on all the Denford latest types software i.e. VR Milling, VR Turning, Quickcam Pro etc, the security codes all have the same file name i.e. SecKey.tff. If you use Regrights it will tell you what Denford software the SecKey.tff is registered for and the number of licence(s)