Hi,
I have decided to install a new control system in my Easimill and have very carefully removed a number of original parts from the machine thinking that other owners might be interested in getting hold of some spares? For simplicity I have listed the parts on Ebay, search for Denford.
I have listed the Digiplan stepper drivers, the screen, the PNC3 Interface card and the Processor keyboard card including VDU board.
At the time I started dismantling everything was working and I have been very carefull so I would expect the parts to be in good shape.
Hope that this gives someone some help.
Ian
PS I also have a brand new casette tape just bought (at great expense!) from North East Electronics if anone is interested.
Posts: 11
Joined: Tue 26 May , 2009 15:20 pm
Replying in the hope you might still have the display from your Easimill re-fit, would it be compatible with an Easimill 3.
Posts: 11
Joined: Tue 26 May , 2009 15:20 pm
Are you still holding spares for a PNC3, if so could you let us know, thanks.
Hi,
Just dropped back into the forum for a look around and spotted your post. Unfortunately the Denford spares went one way or another quite a while ago.
Sorry
Ian
Just dropped back into the forum for a look around and spotted your post. Unfortunately the Denford spares went one way or another quite a while ago.
Sorry
Ian
Ian