Is this a Denford

General support, help and advice for Denford CNC machines (old and new)

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
rasp
CNC Expert
CNC Expert
Posts: 126
Joined: Wed 06 Feb , 2008 18:33 pm

Is this a Denford

Post by rasp » Sun 17 May , 2009 20:01 pm

The title says it all .

https://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 3DWatching

Graham
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Mon 18 May , 2009 8:05 am

This looks like its a CONECT Router. We did a VR Milling software version for this machine at one time, I think it needed an EPROM upgrade as well to get the VR Milling software to run.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 19 May , 2009 8:40 am

It sounds like the guy already has the version of VRMilling v2 which will connect to the Conect machines, so the EPROM must be up to date.
I must say that these machines work ok, but there is no chance of it 3D contouring at any speed - its a simple RS232 command system that takes one move at a time...unless you upgrade it to a Mach 3 system and update the motors and drives
Top
Post Reply

Return to “Machines”