Fapt ladder II request

[greenery]

Dear All

I want to read and modify ladder from fanuc OM B and C. But I do not have Fapt ladder II. Can anybody help me out.

Best regards

[Martin]

I think we borrowed a programing unit to write the Fanuc Ladders on.

Not sure where it came from but pretty sure we have not had one for several years.

[greenery]

I think we borrowed a programing unit to write the Fanuc Ladders on.

Not sure where it came from but pretty sure we have not had one for several years.

Thanks for your reply. I already had fapt ladder II and III

Regards

[Denford Admin]

I've uploaded all that we have here:
viewtopic.php?t=1791

We used this version for the more recent 21i controls although I think it will go back to OT(M)-C - but you will need the eprom blower to plug into the PC.
For the OT(M)B controls we will have used the Fanuc PG-Mate programmer which I think is what Martin is on about.

[greenery]

Thanks for your reply

But your Fapt Laddder do not suport for PMC L and M if anybody need this software. This is link to dowload
viewtopic.php?t=1792

I've uploaded all that we have here:
viewtopic.php?t=1791

We used this version for the more recent 21i controls although I think it will go back to OT(M)-C - but you will need the eprom blower to plug into the PC.
For the OT(M)B controls we will have used the Fanuc PG-Mate programmer which I think is what Martin is on about.

[Denford Admin]

Thanks for this.

BTW, how do you intend to blow the eproms ? Does this software give you a standard hex file that would allow any eprom blower to be used ? I always thought Fanuc would only ever allow their own blowers to be used (all at extortionate prices of course)

[greenery]

Thanks for this.

BTW, how do you intend to blow the eproms ? Does this software give you a standard hex file that would allow any eprom blower to be used ? I always thought Fanuc would only ever allow their own blowers to be used (all at extortionate prices of course)

You can buy from Korea
https://www.cadcam.co.kr/

[Denford Admin]

Excellent ! - that link may well come in very handy one day..

[greenery]

Excellent ! - that link may well come in very handy one day..

Do you have programming manual for Fapt Ladder II and Fapt ladder II manual for PC.

[Steve]

We probably do but it will be subject to copyright.

We could not scan it.

[debinyang]

I wrote two software on dos:
1.convert #ex ---> oe1,oe2 for writing eprom
2.convert oe1,oe2--->#ex for discompile and display ladder
https://www.cncb3h.com ydebin@yahoo.com

[debinyang]

if using my converter software you can use general eprom w/r
to process fanuc pmc. ANd need not to use fanuc eprom w/r its too expensive and has to use a transformer from 220v to 100v.
ydebin@yahoo.com

[debinyang]

hi first floor!

may be fanuc 0mb 0mc has two eprom chips. so it's used fapt ladder soware.
ladder ii is used for fanuc power mate d/h,and fanuc 15,16,18.