Tool Turret not turning on NovaTurn

All info relating to the Denford NovaTurn CNC lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Kholden
Posts: 26
Joined: Thu 02 Mar , 2006 15:19 pm
Location: Ohio - USA
Contact:
Contact Kholden

Tool Turret not turning on NovaTurn

Post by Kholden » Mon 08 May , 2006 16:58 pm

Customer Issue:

The tool turret is not turning on a Novaturn. It was working earlier in the day. Turret gets very hot, and the fuses have been checked and are all fine. :(
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Tue 09 May , 2006 7:42 am

Are there any error messages on the sceen ?
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 09 May , 2006 9:56 am

If you try to index the turret - can you hear the turret motor running ? - you may have to remove the motor from the body to be sure
If the motor runs but the turret doesn't, then it is going to need servicing/replacing
Top
Post Reply

Return to “NovaTurn”