USB Connection problem

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

USB Connection problem

Post by bradders » Thu 04 May , 2006 10:07 am

I have to reinstall the Baldor USB Driver on my PC everytime I want to reconnect to my machine
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Thu 04 May , 2006 10:09 am

If you have multiple USB ports on your PC then when you install the VR Milling software (I.e. with the Baldor driver) it just detects the one you are plugged into and no others, you can :-

A. Delete all references to the Baldor USB Driver in Control Panel
B. Power up the Machine and the PC, then plug the USB cable into the
USB port on the PC and let it autodetect the the Machine
C. Install the Baldor driver off the VR Milling CD
D. Repeat the above for all other USB port on the PC
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 04 May , 2006 16:42 pm

You can download the current Baldor USB device driver files here:

https://www.denfordata.com/downloads/usb_v1_0_0_3.zip
(two driver files zipped up - 14Kb)


They (Baldor) state that if you plug into a different USB port, then you will have to re-install the driver again, or plug it back into the original port.
I recommend you unzip the above file onto your C:\ drive so you can find it again without having to find one of our CD's
Top
Post Reply

Return to “Software”