No spindle Speed on Reinstalled DOS V 1.42. Mirac PC's

[bradders]

We have a problem with our 3 Mirac machines. The spindle will not run
on any of them - this is a bit odd! Machines are free standing and not
on a network.

Spindle speed is shown as zero when we try to start spindle. I can only
assume that there is a setting that may have been changed by someone.
Can you help resolve this?

[bradders]

Can you tell me what machines you have?

Has the software been reinstalled recently ?

Is there speed override know on the machines ? are they turned up ?

What version of Denford software are your running to control the machines ?

[bradders]

The answer to your Qs are as follows:

1. Can you tell me what machines you have?

MIRAC PCs

2. Has the software been reinstalled recently ?

NO - THE MACHINES HAVE BEEN WORKING NORMALLY

3. Is there speed override know on the machines ?

YES - SPINDLE SPEED OVER RIDE

4. are they turned up ?

YES - THE PROBLEM IS ON ALL THREE MACHINES AND THIS HAS BEEN CHECKED.

5. What version of Denford software are your running to control the machines ?

MIRAC STEPPER V1.42

[bradders]

Try putting the following line in the FLSTEP.OPT File

nopots 0