Download the Versalaser CPU Initialization auto Z and rotary calibration pdf from here:
https://www.denfordata.com/pdfs/versalas ... ration.pdf
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Attachments:
- versalaser-cpu-initialization-auto-z-and-rotary-calibration.gif (38.44 KiB) Viewed 25678 times
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Posts: 33
Joined: Sun 22 Apr , 2012 19:24 pm
Hi Just reading how to reset and am a little confused at Step 4 on the pdf. It says if you have purchased proceed to step 6. Which wants you to set the 1.5 lens up. Surely this should read If you have not purchased other lens kits, skip to step 6
Or do I have it wrong?
Pete
Or do I have it wrong?
Pete