mitsubishi control / repairs

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
rogdog
Posts: 1
Joined: Sat 28 Jul , 2007 11:42 am
Location: uk

mitsubishi control / repairs

Post by rogdog » Sat 28 Jul , 2007 12:17 pm

Hello
I'm just about to buy a Takumi machine with a Mitsubishi control and am based in S/Yorkshire.
Can anyone recommend a Mitsubishi specialist engineer for repairs?preferably an independant one man band type.
Also I could do with a few fellow mitsubishi user contacts to share info on alarms, parameters, programming, problems, and quirks. I think it is a 520 system.
I'm fully conversant with Fanuc but have not used Mitsubishi
fanuc & mitsubishi user
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 30 Jul , 2007 9:28 am

I'm sure there are plenty out there, but I don't know any - have never got involved with a Mitsi Control before - only the PLCs

You should try the electrical wholesalers in your area who deal with Mistubishi - I'm sure they'll have a list of local experts.
Top
Post Reply

Return to “Electronics”