Triac VMC Error- Bad or missing command interpreter

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Triac VMC Error- Bad or missing command interpreter

Post by bradders » Wed 11 Jul , 2007 12:20 pm

My Triac VMC, manufactured 1998 is giving the following error

When the machine is switched on the following error message appears

Bad or missing command interpreter
Enter correct name of command interpreter (e.g. c\command.com)

Any ideas ?
Last edited by bradders on Thu 12 Jul , 2007 9:10 am, edited 1 time in total.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 12 Jul , 2007 9:07 am

Sounds like either:

The boot floppy disk has become corrupt
The floppy disk has been taken out :shock:
The floppy disk settings in bios are wrong
The boot floppy drive has failed
The floppy disk cables have come loose etc....
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Thu 12 Jul , 2007 11:35 am

Feed back from machine owner

The solution was to find the original floppy disc & tell the computer to look there for the required program. Previously this was not necessary so I now need to copy the file from the floppy onto the hard drive.
Top
Post Reply

Return to “Triac”