Pausing between blocks

[dhop125]

My mirac pc pauses between each block of code.
For example, if the program was to read:
N010 G01 X15 Z0
N015 G01 X15 Z-5
N020 G01 X15 Z-20
Then the feed would pause for a considerable time at Z-5 leaving a gouge in the workpiece as it chatters.
( I know you would not normally use such a code as above but it's just for illustration)

I have seen this issue before in milling, where the solution was to use G64. But the miracle doesn't recognise it.
I believe it is a denstep board but can't be sure, I'm not able to get access to the box to check.

Anyone come across this before?

[Steve]

What version of software are you using?

Have you got turbo turned on on the control panel?

[dhop125]

Software is VR turning v1.49.0.0
Sorry, I'm new to vr turning! you'll have to point me in the direction of the control panel...
Do you mean machine parameters? There's a check box for high speed cutting under "machine capability"?

Thanks
Duncan