Senior Vertical (knuckle) head - gear specs

[Andy B]

Admin,

Do the drawings exist for the helical gears in the TS vertical head (the non-quill type)?
A poster on the Yahoo! TS group has asked.

I have a copy of the Denford assembly drawing for this, entitled "TS Vertical Milling Attachment", showing the 2 gears as items 6 & 15. Unfortunately there is no drawing number, and I can't remember exactly where all the Denford Senior drawings were now.

Thanks,
Andy

[Denford Admin]

Sorry I can't find any part drawings either, I think this is the assembly you already have..

Might be worth asking IV if we have any more detail - I can't see why he'd go to the trouble to trace the assembly drawing, but not show any drawing ref's for each part.

[Andy B]

Thanks.
PM sent to IV.

Andy

[Andyozz]

Thanks.
PM sent to IV.

Andy

Hello Andy..... Did you have any luck with the drawings for the Knuckle head gears and input shaft..... I have to make a new shaft and gear ...... Fingers crossed

Regards
Andy

[Rippor2]

Anyone know where i can get this drawing of the vertical head i have bought one in pieces with crashed gears these are being made now but i have a box of shims and thrust bearings with no idea where they go.

Bob

[Andy B]

I should have it somewhere but it's not scanned yet.
There is a whole bunch of useful large drawings that I was working through to repair so they won't snag as they go through the scanner. I'll see if I can find it.

Andy

[Andy B]

Found my photo of the vertical head drawing.
Posted here - viewtopic.php?f=53&t=3762
Andy