Good day,
I am a new owner of a TDS 1 LS.
It dates from around the 60's and was used in a school but was in storage for quite some time.
Sadly some parts has gone missing over the years.
I will be stripping it down, rebuilding and restoring it to its former glory for use in my workshop.
For the moment I am looking for the following drawings. I do hope the are available.
ML 105-402
ML 105-403
Many thanks
D
New TDS 1 LS owner
Moderators: Martin, Steve, Mr Magoo
-
Andy B
- CNC Guru
- Posts: 396
- Joined: Mon 20 Nov , 2006 18:19 pm
- Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
- Location: East Midlands, UK
Re: New TDS 1 LS owner
Note to any future readers - All inquiries for drawings related to manual lathes are best put on the Viceroy page - here.
They'll be noticed more easily there!
Andy
They'll be noticed more easily there!
Andy