CNC Guru
CNC Guru
Posts: 1929
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse
CNC Guru
CNC Guru
Fagor 8020T

Post by Martin »

Does anyone have a set of electrical drawings for a EasiTurn fitted with a FAGOR 8020 T control.
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Wed 09 Oct , 2013 16:56 pm
Hardware/Software: None yet!
CNC Apprentice
CNC Apprentice
Re: Fagor 8020T

Post by nemo1966 »

Got these at present - still looking through pile of manuals.
IMG_20200815_173241950_HDR.jpg
IMG_20200815_173241950_HDR.jpg (65.81 KiB) Viewed 21946 times
IMG_20200815_173231448_HDR.jpg
IMG_20200815_173231448_HDR.jpg (59.48 KiB) Viewed 21946 times
IMG_20200815_173222901_HDR.jpg
IMG_20200815_173222901_HDR.jpg (67.71 KiB) Viewed 21946 times
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Wed 09 Oct , 2013 16:56 pm
Hardware/Software: None yet!
CNC Apprentice
CNC Apprentice
Re: Fagor 8020T

Post by nemo1966 »

Still need them? Just found a full set with transformer diagrams etc :shock:
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Wed 09 Oct , 2013 16:56 pm
Hardware/Software: None yet!
CNC Apprentice
CNC Apprentice
Re: Fagor 8020T

Post by nemo1966 »

CNC Guru
CNC Guru
Posts: 1929
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse
CNC Guru
CNC Guru
Re: Fagor 8020T

Post by Martin »

Thanks for posting.
Posts: 2
Joined: Thu 15 Dec , 2022 0:42 am
Re: Fagor 8020T

Post by ParticleFire »

hi!
Do you still have the Installation and Start-up manual for Fagor 8020T?
I need it and can´t found it!, could you upload it, please?

Thank you!
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Wed 09 Oct , 2013 16:56 pm
Hardware/Software: None yet!
CNC Apprentice
CNC Apprentice
Re: Fagor 8020T

Post by nemo1966 »

Sorry you message was stuck in my spam trap. I have them bit no way now of copying or uploading.
Post Reply

Information

Moderators

Martin, Steve, Mr Magoo