TDS 1/1 Feeds and speeds plate

dakes55 · Post by **dakes55** » Thu 13 Apr , 2017 18:19 pm

Just wondered if anyone could send me a good picture of the speeds and feeds plate that goes below the dial, mine is missing, I might be able to make one on my laser with a good picture.
Thanks

LesT · Post by **LesT** » Thu 13 Apr , 2017 20:07 pm

Hi,
I think what the plate says may depend on the model of lathe,i.e. Metric or Imperial.
Mine is metric.

dakes55 · Post by **dakes55** » Thu 13 Apr , 2017 20:35 pm

Yes mine is also metric

Pete. · Post by **Pete.** » Thu 13 Apr , 2017 21:24 pm

Is this the 12345 dial on the gearbox?

If so I might have a spare

dakes55 · Post by **dakes55** » Fri 14 Apr , 2017 8:53 am

Hi, yes the dial on mine is 1,2,3,4,5, do you want to sell it to me?
Thanks.

Pete. · Post by **Pete.** » Fri 14 Apr , 2017 23:43 pm

Is this the thing you need?

dakes55 · Post by **dakes55** » Sat 15 Apr , 2017 8:52 am

Yes thats the one i need

Pete. · Post by **Pete.** » Sat 15 Apr , 2017 9:42 am

Ok send me a message with your address, pay the postage and it's yours.

I seriously recommend you make your best effort to change that front plate without removing the gear change lever though. It has an odd number of splines and teeth on the rack gear and if the pinion disengages it's easty to trash the gears by not getting it back in with full engagement.

Artysmarty · Post by **Artysmarty** » Wed 16 Oct , 2019 13:18 pm

Hi
Long shot here but can you remove that front gearbox cover without removing the gear selector lever.

Denford Software & Machines

Denford Software & Machines

TDS 1/1 Feeds and speeds plate

TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate

Re: TDS 1/1 Feeds and speeds plate