When you close down any Denford software which uses OpenGL 3D, then you get the message Context Activation Failed : C0070006 and the application crashes
(eg, VRMilling5, QuickCAM Pro, QuickCAM 3D, QuickCAM 2D)
Context Activation Failed : C0070006
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
We have found an incompatibilty within the ATI graphics card drivers - apparently upto v6.5 was OK, but more recent version of the ATI stuff (catalyst) causes our software to crash.
A solution has been made "around" the problem in all our software which will be released soon (after the Christmas holidays)
In the meantime, lower the hardware acceleration until the problem disappears
A solution has been made "around" the problem in all our software which will be released soon (after the Christmas holidays)
In the meantime, lower the hardware acceleration until the problem disappears