I wanted to share this with everyone who ownes an older (1984 and older) Orac lathe. This is the offline editor and loader program that allows you to connect a computer to the RS323 port. It allows you to program and upload your programs to your lathe. I hope this helps someone out.
Be sure to read the install instructions included with the zip file.
Provided as is as I haven't had a chance to play with it.
Adam
Posts: 5
Joined: Mon 04 Dec , 2006 19:19 pm
Attachments:
Orac TDS/O/R/CNC
S/N 32155
S/N 32155
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
