unknown error messages

Large519 · Post by **Large519** » Fri 23 May , 2014 23:33 pm

Hi, I am having issues connecting pc to machine (microrouter pro), I get the following error messages.

Drive reports incorrect toggle bit.????
And
Must use a setxxxlink function.????

Can anyone help and advise what to do??

Thankyou

Martin · Post by **Martin** » Sat 24 May , 2014 0:08 am

What is the colour of the 7 segment LED in the electrical panel?
If it is not red then try to connect using EasyUgrader.

Large519 · Post by **Large519** » Sat 24 May , 2014 0:26 am

Hi it was green.

I have just tried the easy up grader, but still get error message

Drive reports incorrect toggle bit.....

Have I got baud rate, bit rate etc setup wrong,??

Do you know what these should be set at?

Large519 · Post by **Large519** » Sun 25 May , 2014 1:08 am

After much investigation it would appear to be an issue with the pc, I was originally running mach3 on the system with my other router, but now I was planning to run a pro router on the same system using vr milling, a windows optimization check list I had done recommended by mach clearly has issues with other programmes.

Information