This is my first post .. so greetings Denford Community!
I've just bought a Novamill without the control box or leads (for £500) - it's had very little use.
Therefore, I'm looking for either a used control box and leads ... or ... a new control box (or kit) with leads (so if anyone can point me in the right direction, I would be very grateful).
Attachments:
- Novamill1.JPG (111.68 KiB) Viewed 4557 times
- Novamill2.JPG (125.74 KiB) Viewed 4557 times
CNC Apprentice
Bargain! 
I sold my electronics box and used new steppers and controllers. Now the same package sits in a box the same size as a shoe box
.
The only expensive bit will be the spindle motor controller.
I sold my electronics box and used new steppers and controllers. Now the same package sits in a box the same size as a shoe box
.The only expensive bit will be the spindle motor controller.