Tech Design CNC Mill 1996 Need Info

All info relating to the Denford Starmill CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
bob11x
Posts: 5
Joined: Tue 04 Feb , 2014 18:01 pm
Hardware/Software: Tech Design CNC Mill SP40703A Electronics #OC00134827

Tech Design CNC Mill 1996 Need Info

Post by bob11x » Tue 04 Feb , 2014 19:56 pm

I acquired a Tech Design by Lab Volt CNC Mill. Tag says:

Tech Design
Machine S/N: SP40703A
Electronics S/N: OC00134827
Nov 1996

I called Lab Volt and they said it probably was built by Denford as they switched in 1997 to their own design. It is not in front of me but the mill says "Made in USA" which makes me wonder if I got correct info.

I have a machine that the cords have been cut and I have no paperwork. Any info available? Wiring Diagrams? Software ? Hardware differences to look for? Conversion possibilities?

Any help or suggestions would be greatly appreciated.

Thank you.

bob
140204CNCMILL2.jpg
140204CNCMILL2.jpg (110.61 KiB) Viewed 10193 times
Attachments
140204CNCMILL1.jpg
140204CNCMILL1.jpg (104.19 KiB) Viewed 10193 times

Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Tech Design CNC Mill 1996 Need Info

Post by Martin » Tue 04 Feb , 2014 21:06 pm

It is a Micromill. The early Micromills were made by Denford USA but production was later switched to the UK. If you search the forum for Micromill you should find plenty of technical details.

bob11x
Posts: 5
Joined: Tue 04 Feb , 2014 18:01 pm
Hardware/Software: Tech Design CNC Mill SP40703A Electronics #OC00134827

Re: Tech Design CNC Mill 1996 Need Info

Post by bob11x » Sat 08 Feb , 2014 3:50 am

Thanks for the info - I will check it out!

Post Reply