R232 Cable Black box connections

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
Large519
CNC Expert
CNC Expert
Posts: 101
Joined: Wed 20 Mar , 2013 22:34 pm
Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape

R232 Cable Black box connections

Post by Large519 » Wed 08 Jan , 2014 17:00 pm

Hi, Is the wiring connection on this 25pin connector on the inside of my microrouter black box correct? As I would like to make a direct connection with the Baldor board from PC, and I assumed there should be more wiring than this?
Image
Top
Martin
CNC Guru
CNC Guru
Posts: 1916
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: R232 Cable Black box connections

Post by Martin » Wed 08 Jan , 2014 18:38 pm

viewtopic.php?f=36&t=2384&p=8630&hilit=BI01812A#p8630
Top
Large519
CNC Expert
CNC Expert
Posts: 101
Joined: Wed 20 Mar , 2013 22:34 pm
Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape

Re: R232 Cable Black box connections

Post by Large519 » Wed 08 Jan , 2014 19:40 pm

Thanks martin, that's made that alot clearer.
Top
Post Reply

Return to “Electronics”