I've created an imperial PNC post processor attached.
Just add the file to this directory:
C:\Documents and Settings\All Users\Application Data\Denford\Posts
Please let me know if it works ok and it will go onto the next releases.
Triac PNC 3 Imperial mode post processor
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Triac PNC 3 Imperial mode post processor
- Attachments
-
- Triac PNC (Inch).ppl
- (1.42 KiB) Downloaded 1363 times
-
Large519
- CNC Expert
- Posts: 101
- Joined: Wed 20 Mar , 2013 22:34 pm
- Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape
Re: Triac PNC 3 Imperial mode post processor
Can you make a metric processor for the pnc3, and will it run in mach3
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Triac PNC 3 Imperial mode post processor
The metric version was done first (in 2006!) so will already be on any Denford CAM software
- Attachments
-
- Triac PNC.ppl
- (1.41 KiB) Downloaded 1195 times