Starturn 4 Spindle motor controller

All info relating to the Denford StarTurn CNC lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
flyingmike
CNC Apprentice
CNC Apprentice
Posts: 73
Joined: Tue 19 Apr , 2011 8:38 am

Starturn 4 Spindle motor controller

Post by flyingmike » Mon 09 Apr , 2012 20:06 pm

Does anyone know if an emergency stop can be incorporated into the spindle controller. There is a unused pair of pins coming out of the controller and I was wondering if this was some kind of inhibit terminal like I have on another DC motor controller.

ta

Mike
Attachments
DSC_0430.JPG
DSC_0430.JPG (106.96 KiB) Viewed 12040 times

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Starturn 4 Spindle motor controller

Post by Denford Admin » Wed 11 Apr , 2012 14:38 pm

What is that controller - is there any i.d. on the silkscreen ?
If it's a Jay Electronics, I could never find much info on it in the past.
Have a look through the electrical drawings for the starturns, the terminals may still be marked up even if they're not used.

flyingmike
CNC Apprentice
CNC Apprentice
Posts: 73
Joined: Tue 19 Apr , 2011 8:38 am

Re: Starturn 4 Spindle motor controller

Post by flyingmike » Wed 11 Apr , 2012 22:04 pm

I cant see any make or number on the board :(

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Starturn 4 Spindle motor controller

Post by Denford Admin » Thu 12 Apr , 2012 9:07 am

From the looks of it, I doubt it will have an inhibit input. It's more likely to run as soon as main power is applied to it (via a 10amp relay possibly)

flyingmike
CNC Apprentice
CNC Apprentice
Posts: 73
Joined: Tue 19 Apr , 2011 8:38 am

Re: Starturn 4 Spindle motor controller

Post by flyingmike » Thu 12 Apr , 2012 9:21 am

I have it running ok. I added a relay in so I could use the original on/off buttons on the front panel, the original relay being on the control board that is now removed. I`m just thinking of different ways to interface an emergency stop in to the motor control.

Post Reply