Hi! I`m just about to take out the original driver boards and some of the power supply parts from my starturn 4 as I am upgrading to new stepper motors and controllers. If anyone is interested in the electronics and the original stepper motors then let me know!
Mike
Starturn 4 electronics
Moderators: Martin, Steve, Mr Magoo
-
flyingmike
- CNC Apprentice
- Posts: 73
- Joined: Tue 19 Apr , 2011 8:38 am
Re: Starturn 4 electronics
Here are all the bits I have for sale...
The stepper motors would be included as well.
The stepper motors would be included as well.
- Attachments
-
- DSC_0435.JPG (231.63 KiB) Viewed 4713 times
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Starturn 4 electronics
It'd be worth putting on what type the drives are (eg, parker SD2)
And do you still have the other side of the connector to the drives ? ie, so people can solder wires to it if they weren't replacing like for like
And do you still have the other side of the connector to the drives ? ie, so people can solder wires to it if they weren't replacing like for like
-
flyingmike
- CNC Apprentice
- Posts: 73
- Joined: Tue 19 Apr , 2011 8:38 am
Re: Starturn 4 electronics
Good idea 
The main board says Syntel 1984 and the drivers are PKS Digiplan SD2
I would include all the connectors too, but for now, they are still on the wiring loom.
The main board says Syntel 1984 and the drivers are PKS Digiplan SD2
I would include all the connectors too, but for now, they are still on the wiring loom.
-
flyingmike
- CNC Apprentice
- Posts: 73
- Joined: Tue 19 Apr , 2011 8:38 am