I just got my Orac turret working properly under Mach3. I need a set of bushings to load into the (4) 19mm holes in the ATC turret to hold drills, endmills, etc. Since I've got to make them anyway, I'd prefer to have them match the style of the factory parts as closely as possible. Does anyone have drawings, or pictures or measurements of the factory parts?
thanks,
v
Last edited by vandal968 on Mon 12 Mar , 2012 18:45 pm, edited 1 time in total.
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Site Admin
This might be it :
/viewtopic.php?f=42&t=3299
/viewtopic.php?f=42&t=3299
Perfect! Exactly what I was looking for.
Thank you,
v
Thank you,
v