Wanted Black cabinet locks
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 12
- Joined: Thu 15 Dec , 2011 12:56 pm
- Hardware/Software: 1995 Denford Starmill
smartstep 3
millcam designer v2.2a
Fanuc md
2d design
Wanted Black cabinet locks
Hi someone might be able to help me, i am after a couple of little black locking knobs which are on the black cabinets (mine is a starmill) i have the locks but no keys and health and safety needs mean i have to lock the cabinets so my pupils don't electricute themselves. If not does anyone know where to go to get keys cut from the numbers on the locks?
Re: Wanted Black cabinet locks
Most of the cabinets were made by Rittal and they had a standard key.
These can be locked and unlocked using a pair of neadle nose pliars.
Here is a link to the key required.
https://www.rittal.com/products/ArtikelD ... GB&Dom=com
These can be locked and unlocked using a pair of neadle nose pliars.
Here is a link to the key required.
https://www.rittal.com/products/ArtikelD ... GB&Dom=com
-
- Posts: 12
- Joined: Thu 15 Dec , 2011 12:56 pm
- Hardware/Software: 1995 Denford Starmill
smartstep 3
millcam designer v2.2a
Fanuc md
2d design
Re: Wanted Black cabinet locks
sadly mine does not! so still asking for help here
- Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Wanted Black cabinet locks
Can you post a photo ?