Hi,
I may be getting a ZeroTurn and was wondering if anyone knows the spindle bore?
Hood
ZeroTurn spindle bore
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: ZeroTurn spindle bore
Sorry - I've had a look and we haven't seen any Zeroturn brochures when scanning the old documents in.
These machines are pretty rare and there is definately a lack of info about them here
These machines are pretty rare and there is definately a lack of info about them here
Re: ZeroTurn spindle bore
Thanks
Yes, had a look through the info on the forum and the brochure mentions 65mm spindle but that seems to be the outer. I think I also read they have a A2-5 spindle nose so was thinking 38mm would be about right.
Not sure if I will be getting it anyway as I have not heard back
Hood
Yes, had a look through the info on the forum and the brochure mentions 65mm spindle but that seems to be the outer. I think I also read they have a A2-5 spindle nose so was thinking 38mm would be about right.
Not sure if I will be getting it anyway as I have not heard back
Hood