BT35 tool holders

mickgc29 · Post by **mickgc29** » Wed 21 Sep , 2011 20:51 pm

I have just got a denford triac and found a supply of new Nikken BT35 tool holders in sizers 5/16 , 1/4 , 3/16 and shell holder

is there any body else needing these tool holders so we could share postage cost

cheers Mick

jpmiller · Post by **jpmiller** » Wed 21 Sep , 2011 21:06 pm

My triac is bt30 it has a bt30/70/er 32 collet
In it at the moment I found the same thing from
Tool holders direct if anyone is needing them.

mickgc29 · Post by **mickgc29** » Wed 21 Sep , 2011 21:37 pm

my triac as the tool changer and as the BT35 tool holders well i hope so lol as i have just oreder a few of them

cheers Mick

angel-tech · Post by **angel-tech** » Thu 22 Sep , 2011 17:17 pm

Mick if your triac has the 6 station carousel then it will have a BT35 spindle, it's the triac with the eight station carousel that has the BT30 spindle.

Lone_Ranger · Post by **Lone_Ranger** » Fri 23 Sep , 2011 9:05 am

mickgc29 wrote:I have just got a denford triac and found a supply of new Nikken BT35 tool holders in sizers 5/16 , 1/4 , 3/16 and shell holder

is there any body else needing these tool holders so we could share postage cost

cheers Mick

Just my personal opinion but I think you should try to stick to Metric toolholders, much easier to get tooling for them

.

Information