Greetings,
Firstly: can anyone recommend a Quick Change toolpost for a Viceroy ?. Some are cheaper, some are dearer, but whcih is best ?
Secondly: has anyone got a QC toolpost they would like to sell ?
Cheers,
Les.T.
CNC Expert
Posts: 119
Joined: Wed 11 Aug , 2010 14:17 pm
Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
Location: Scotland !
CNC Expert
Posts: 19
Joined: Mon 12 Apr , 2010 16:14 pm
Hi - i have a proper Dixon toolpost and 17 holders for my 280vs. I do have a spare 4 way indexing toolpost as well if you are interested but i find the QC one much better. Chronos and RDG do a copy of the Dixon toolposts which should be fine.
CNC Expert
Posts: 119
Joined: Wed 11 Aug , 2010 14:17 pm
Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
Location: Scotland !
CNC Expert
Thanks for the reply, maybe I'll get a QC toolpost for christmas (if I can afford it !),andyevans wrote:Hi - i have a proper Dixon toolpost and 17 holders for my 280vs. I do have a spare 4 way indexing toolpost as well if you are interested but i find the QC one much better. Chronos and RDG do a copy of the Dixon toolposts which should be fine.
Cheers,
Les.T.