Pnc2 wiring diagram needed help pls

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
jpmiller
Posts: 31
Joined: Wed 23 Feb , 2011 9:16 am
Hardware/Software: Denford easyturn pnc2
Converted to mach3

Denford triac servo /G simple/quickcam
Location: Dumbarton scotland

Pnc2 wiring diagram needed help pls

Post by jpmiller » Sun 08 May , 2011 11:57 am

As above for the easiturn 3 pnc2
If anyone has one.

Thanks
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Pnc2 wiring diagram needed help pls

Post by Denford Admin » Mon 09 May , 2011 8:43 am

Sorry I have no wiring diagrams for pnc2 easiturn.

Maybe this is close ?
viewtopic.php?f=54&t=3267
Top
jpmiller
Posts: 31
Joined: Wed 23 Feb , 2011 9:16 am
Hardware/Software: Denford easyturn pnc2
Converted to mach3

Denford triac servo /G simple/quickcam
Location: Dumbarton scotland

Re: Pnc2 wiring diagram needed help pls

Post by jpmiller » Fri 13 May , 2011 8:12 am

Ok thanks I will have a good look at this.
Top
Post Reply

Return to “EasiMill / EasiTurn”