Installed a new PC to use our VRTurning software. It asked for dongle. I ran the registratrion floppy that came with the CD. Still asked for dongle. I followed instructions on the #1012 pdf sheet...
STILL ASKS FOR DONGLE! Any suggestions?
The VRMilling software works fine after #1012 instructions but obviously not with the VRTurning.
HELP!
Thanks all.
-Bob Cooper
Lab & Facilities Mngr.
Morehead State University
Morehead Kentucky 40351
dongle not found
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Bob,
There should be 2 files on your floppy registration disc, a *.ini and a *.exe. Just try double clicking the *.exe file and this should run and copy part of the *.ini file to VRTURN.INI in the directory where the VR Turning is installed. Open this directory and if it has been a success then you should see a section in [Flash] (square brackets) and below it your school / college details.
e.g.
[Flash]
Flash_User=Denford Ltd Birds Royd Brighouse West Yorkshire England HD6 1NB 1 User Licence
Flash_Code=
There should be 2 files on your floppy registration disc, a *.ini and a *.exe. Just try double clicking the *.exe file and this should run and copy part of the *.ini file to VRTURN.INI in the directory where the VR Turning is installed. Open this directory and if it has been a success then you should see a section in [Flash] (square brackets) and below it your school / college details.
e.g.
[Flash]
Flash_User=Denford Ltd Birds Royd Brighouse West Yorkshire England HD6 1NB 1 User Licence
Flash_Code=