lathe missing shaft and gears what parts do i need
Moderators: Martin, Steve, Mr Magoo
lathe missing shaft and gears what parts do i need
missing gearbox shaft and gears
- Attachments
-
- the lathe resprayed the doors hammered enamel
- viceroy lathe 004 (Medium).jpg (71.31 KiB) Viewed 4520 times
-
- no gears
- viceroy lathe 002 (Medium).jpg (84.63 KiB) Viewed 4520 times
-
- missing shaft
- viceroy lathe 001 (Medium).jpg (79.44 KiB) Viewed 4520 times
-
LesT
- CNC Expert
- Posts: 119
- Joined: Wed 11 Aug , 2010 14:17 pm
- Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc. - Location: Scotland !
Re: lathe missing shaft and gears what parts do i need
Hi,
I think you may have a bit of a problem.
As far as I can see you have a slightly different version of the gearbox shown in the scans.
The bits you need look to be shown on section E-E.
There are item drawings available as Pdf's (look for the ML115 section),
but as to how to make or get any of these items,
I think that could be a bit difficult.
Good luck anyway.
Cheers,
Les.T.
PS if anyone can stitch the drawings together that might be helpful
I think you may have a bit of a problem.
As far as I can see you have a slightly different version of the gearbox shown in the scans.
The bits you need look to be shown on section E-E.
There are item drawings available as Pdf's (look for the ML115 section),
but as to how to make or get any of these items,
I think that could be a bit difficult.
Good luck anyway.
Cheers,
Les.T.
PS if anyone can stitch the drawings together that might be helpful
- Attachments
-
- The other Half of ML 115/900
- scan0002.png (42.23 KiB) Viewed 4503 times
-
- Half of ML 115/900
- scan0001.png (50.94 KiB) Viewed 4503 times
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: lathe missing shaft and gears what parts do i need
I've stitched the drawing together and added some more I think are relevant to this thread:
viewtopic.php?f=50&t=2986&p=11420#p11420
viewtopic.php?f=50&t=2986&p=11420#p11420