dongle not found

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
bobcooper
Posts: 2
Joined: Wed 13 Sep , 2006 22:03 pm
Location: Morehead State University

dongle not found

Post by bobcooper » Wed 13 Sep , 2006 22:46 pm

Installed a new PC to use our VRTurning software. It asked for dongle. I ran the registratrion floppy that came with the CD. Still asked for dongle. I followed instructions on the #1012 pdf sheet...
STILL ASKS FOR DONGLE! Any suggestions?
The VRMilling software works fine after #1012 instructions but obviously not with the VRTurning.
HELP!

Thanks all.
-Bob Cooper
Lab & Facilities Mngr.
Morehead State University
Morehead Kentucky 40351
Top
Martin
CNC Guru
CNC Guru
Posts: 1916
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Post by Martin » Thu 14 Sep , 2006 19:31 pm

Hi Bob,

Sounds like it may be easier to coppy the licence disc manually.


You need to open the text file on the licence disc then coppy the text & paste it into the VRTurning.ini file.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Sat 16 Sep , 2006 19:16 pm

There is also a slight chance that the disk has been created with the wrong data, or is corrupt.

Contact your supplier if you really can't get anywhere

8) - Admin on holiday
Top
Post Reply

Return to “Software”