I have reworked my triac and have the left over parts to pass on.
The plate on the electronics section is 11/88 and serial number 354,
the complete motherboard that was working before i stripped the unit, the inbuilt monitor and two of the Parker drives for the x and y axis.
The complete front panel with the keyboard and untested mini tape drive, and also the remote monitor.
Parts are located in south east london, If anybody is interested please contact me.
Regards Peter
hi do you still have the spare parts im sure they are gone by now if not let me know
Posts: 2
Joined: Mon 19 Apr , 2010 9:19 am
Hello
Do you stillhave the eurostep card ( the one its for communication inside of the controller)
I am interested on it.
Regards
Do you stillhave the eurostep card ( the one its for communication inside of the controller)
I am interested on it.
Regards
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Site Admin
It might be worth PM'ing or emailing HONDAPETE as he probably isn't monitoring this post any longer.
CNC Guru
Posts: 525
Joined: Tue 14 Nov , 2006 12:12 pm
Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3
Location: Quatroland
CNC Guru
i may have one