Page 1 of 1
Starturn pc software and purchase
Posted: Tue 21 Feb , 2012 12:01 pm
by stepheng
Hi, I have been offered a Starturn PC, without any software, What software is available and at what cost, I have used starmill pc and have it operating. Is the vr milling similar to the VRturning ?
Re: Starturn pc software and purchase
Posted: Tue 21 Feb , 2012 13:41 pm
by Denford Admin
Yes they are similar although VR turning is a bit older now than VRMilling v5
What software runs the machine depends on whether it has had a DOS upgrade chip fitted, or USB upgrade.
If not then you'd have to find the DOS software to control it with, preferably, an old PC
DOS Software and Control Boards:
viewtopic.php?t=738