VR CIM and VR ROBOT

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1451
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

VR CIM and VR ROBOT

Post by Steve » Tue 01 May , 2012 1:58 am

Can anyone tell me if these packages will work with Windows 7?

If not what is the last version of windows that could be used?

Thanks.
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Re: VR CIM and VR ROBOT

Post by bradders » Tue 01 May , 2012 13:56 pm

Loaded VR CIM and VR Robot on to a Windows 7 Home PC. It seems to install OK but when you try to open rooms you get an Access Viloation Error in VL-Link.exe. I suspect this is the VISCAPE graphic driver that is causing the problem. Admin may be able to give a more exact report.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: VR CIM and VR ROBOT

Post by Denford Admin » Fri 04 May , 2012 14:11 pm

It should work with XP mode on windows 7 but I haven't the resources to try it here.
https://www.microsoft.com/windows/virtua ... fault.aspx
Top
Post Reply

Return to “Software”